Parkside 409154 2207 Traduction Des Instructions D'origine page 30

GB MT
tions and the work to be perfor-
med. Use of the power tool for ope-
rations different from those intended
could result in a hazardous situation.
Service:
• Have your power tool serviced
by a qualified repair person
using only identical replacement
parts. This­will­ensure­that­the­safety­
of the power tool is maintained.
Safety instructions for all
applications
Common safety instructions for
grinding, working with wire bru-
shes and cutting grinders:
• This electric tool is to be used as
a grinder, wire brush and cutting
grinder. Follow all safety instruc-
tions, directives, illustrations and
facts which you receive with the
device. If you do not follow these inst-
ructions,­an­electrical­shock,­fire­and/or­
serious injury may occur.
• This electric tool is not suitable
for sanding and polishing. Using
the electric tool in ways for which it is
not intended may cause hazards and
injuries.
• Do not use any accessories that
are not specifically intended and
recommended for this electric
tool by the manufacturer. Simply
because an accessory can be attached
to your electric tool does not guarantee
safe operation.
• The allowable rotation speed
of the attachment tools must be
at least as high as the highest
rotation speed indicated on the
electric tool. Accessories that run fas-
30
ter than the allowable speed can break
and­fly­apart.
• The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool.
Attachment tools which are wrongly
dimensioned­cannot­be­sufficiently­
shielded or controlled.
• Attachment tools with threaded
attachment must fit the threa-
ding of the grinding spindle ex-
actly. For attachment tools which
are mounted through a flange,
the diameter of the hole in the
attachment tool must fit the
mounting diameter of the flange.
Attachment tools which cannot be pre-
cisely attached to the electric tool turn
unevenly, vibrate very strongly and can
ultimately lead to a loss of control.
• Never use damaged attachment
tools. Check attachment tools
such as grinding discs for chip-
ping or cracks, grinding plates
for cracks, wear or strong abrasi-
on and wire brushes for loose or
broken wires before using them.
If the electric tool or the attach-
ment tool falls off, check whether
it is damaged or, use an undama-
ged attachment tool. If you have
checked the attachment tool and
attached it, keep yourself and
any nearby persons beyond the
level of the rotating attachment
tool and allow the device to run
for 1 min. at the highest rotati-
onal speed. Damaged tools usually
break during this test period.
• Wear personal safety equip-
ment. Depending on the appli-
cation, use full face shields, eye
protection or safety goggles. In