Publicité
BX 11 | BX 11 S
| Adaptive wheelchair
8. Roll the casing for support to move the valve into the correct
position. Do this also before inflating the tyre so that the tube is
correctly positioned in the rim shoulder.
60.
Jacket assembly:
1. The undersides of the casing lifters are to be pushed between the
casing and the rim with the side facing upwards.
61.
2. Now use the mantle lifters to throw the mantle bead over the rim.
62.
3. Now pull one of the two casing lifters along the rim flange all the
way around the tyre, thus placing the casing bead behind the rim
flange.
63.
4. Pull the casing lift as far as possible around the tyre.
64.
102
Adaptive wheelchair |
5. If the casing lifter cannot be pulled any further, place the third
casing lifter in the middle of the other two and place it between the
casing and the rim flange.
6. Now throw the mantle over the rim.
7. Inflate the tyre a little, then waltz, then finish inflating.
8. Screw the dust cap onto the valve. Now the wheel can be put back
on the wheelchair, see chapter 4.8.1.
Bischoff & Bischoff GmbH 2024-08-13 - Revision: 3
BX 11 | BX 11 S
65.
66.
67.
68.
103
Publicité
