Publicité
EngLIsh
Do not use unit if switch does not turn it on or off. A unit
•
that cannot be controlled with the switch is dangerous and
must be repaired.
Do not allow debris to be ingested into blower intake.
•
Do not point unit discharge at self or bystanders.
•
Do not use to blow explosive dust, or in areas where
•
air contains explosive dust such as coal, grain, or other
combustible material.
Do not attempt to repair the blower. To assure product
•
safety and reliability, repairs, maintenance, and adjustments
should be performed by authorized service centers.
Do not operate blower in a gaseous or explosive
•
atmosphere. Motors in these units normally spark, and the
sparks might ignite fumes.
Do not overreach. Keep proper footing and balance at
•
all times.
Never leave blower running unattended. Turn power off.
•
Remove the battery pack before connecting the tube.
•
Store idle units. When not in use, the unit should be stored in
•
a dry, high or locked-up place - out of reach of children.
Instructions for compatible batteries and chargers are
•
included for reference in this manual. Read all instruction
manuals included with your battery pack or charger. Read all
cautionary markings on the charger and battery pack.
Disconnect the battery pack from the blower before
•
making any adjustments, changing accessories,
servicing, moving or storing the unit. Such
preventative safety measures reduce the risk of starting the
appliance accidentally.
•
Do not use if appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into water, return
it to a service center.
SAVE THESE INSTRUCTIONS
Residual Risks
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
•
Impairment of hearing.
•
Risk of personal injury due to flying particles.
•
Risk of burns due to accessories becoming hot
during operation.
•
Risk of personal injury due to prolonged use.
SAVE THESE INSTRUCTIONS
Chargers
D
WALT chargers require no adjustment and are designed to be
e
as easy as possible to operate.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
30
i
Your D
WALTcharger is double insulated in
e
accordance with EN60335; therefore no earth wire
is required.
If the supply cord is damaged, it must be replaced only by
D
WALT or an authorised service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•
Safely dispose of the old plug.
•
Connect the brown lead to the live terminal in the plug.
•
Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm
is 30 m.
When using a cable reel, always unwind the cable completely.
Important Safety Instructions for All
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains important
safety and operating instructions for compatible battery
chargers (refer to Technical Data).
•
Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using
battery pack.
WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Electric shock may result.
WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.
CAUTION: Burn hazard. To reduce the risk of injury,
charge only D
WALT rechargeable batteries. Other types of
e
batteries may burst causing personal injury and damage.
CAUTION: Children should be supervised to ensure that
they do not play with the appliance.
NOTICE: Under certain conditions, with the charger
plugged into the power supply, the exposed charging
contacts inside the charger can be shorted by foreign
material. Foreign materials of a conductive nature such as,
but not limited to, steel wool, aluminum foil or any buildup
of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug charger
before attempting to clean.
DO NOT attempt to charge the battery pack with any
•
chargers other than the ones in this manual. The charger
and battery pack are specifically designed to work together.
2
; the maximum length
Publicité
