Publicité
PROBLEMS
The machine raises dust.
The machine leaves dirt on the
ground.
Centre brush does not rotate.
The side brushes do not rotate.
The suction motor does not work.
The filter shaker motor does not
work.
The machine does not start
The battery doesn't hold its charge
TROUBLESHOOTING
CAUSES
Filter clogged.
Filter damaged.
Filter incorrectly fitted.
Safety thermostat tripped
The main brush has collected string
or wire.
The flaps are damaged.
Debris bin full.
Belt broken.
Cutout tripped.
Reduction drive damaged.
Cutout tripped.
Microswitch faulty.
Reduction drive damaged.
Cutout tripped.
Motor damaged.
Safety thermostat tripped.
Cutout tripped.
Motor damaged.
Battery terminals disconnected
Batteries discharged
Emergency stop button pressed
Operator weight-sensing device
faulty
Operator not correctly seated.
Main fuse blown
No liquid
Loose terminal
EN
SOLUTIONS
Shake the filter using the filter
shaker and if necessary remove and
carefully clean the filter
Replace the filter
Fit the filter correctly in position
Remove the heat source from the
debris bin.
Remove the string and wire picked
up.
Replace the flaps
Empty the debris bin
Contact customer service
Reset the fuse
Contact customer service
Reset the fuse
Contact customer service
Contact customer service
Reset the fuse
Contact customer service
Remove the heat source from the
debris bin.
Reset the fuse
Contact customer service
Check
Recharge
Reset.
Contact customer service
Sit correctly in the seat.
Contact customer service
Top up
Tighten
28
Publicité
