Publicité
INTRODUCTION
The thermostat is an electronic PWM/PI thermostat for temperature
control by means of an NTC sensor located either externally or
internally within the thermostat.
The thermostat is for flush mounting in a wall socket. A baseplate
for wall mounting is also available.
This thermostat can be used as a controller for electric room
heating pursuant to EN 50559.
Fig. 1 - Content
• Thermostat
• Sensor
Product programme
OCD5-1999/MCD5-1999
OWD5-1999/
MWD5-1999
IMPORTANT SAFETY INSTRUCTIONS
Fig. 2 - Warnings
To avoid electric shock, disconnect the heating system
power supply at the main panel before carrying out any
work on this thermostat and associated components.
Installation must be carried out by qualified personnel in
accordance with appropriate statutory regulations (where required
by law).
Installation must comply with national and/or local electrical codes.
OCD5/MCD5-1999
OWD5/MWD5-1999
Instruction
English
Clock-thermostat with two sensors:
floor sensor and built-in room sensor.
WiFi Clock-thermostat
with two sensors:
floor sensor and built-in room sensor.
© 2021 OJ Electronics A/S
7
Publicité
