Publicité
Troubleshooting
When operating with different protocols you may have problems
in each mode at the same time. – We recommend reducing the
number of protocols. Deactivate protocols in the locomotive
decoder that are not needed and also deactivate if possible
protocols in the central controller that are not needed.
The locomotive jerks and falters – Check the CV setting for
motor variations, change if necessary, or carry out a reset to the
factory settings.
The locomotive does not run in analog. – The automatic analog
recognition is deactivated and must be activated again (see CV
table).
The locomotive (decoder) does not react. – Check the wiring and
the solder joints, redo if necessary. Check the connector for the
decoder to make sure it has permanent contact and check the
way it was installed.
mfx/DCC operation: Locomotives standing on the layout start
running suddenly during mfx registration. – Deactivate the
automatic analog recognition on these locomotives.
The locomotive does not run. – The function "open doors / close
doors" is still active. Turn off the function "close doors"; after
the sound ends the locomotive will run according to the ABV
that has been set.
38
Disposing
Products marked with a trash container with a line
through it may not be disposed of at the end of their
useful life in the normal household trash. They must
be taken to a collection point for the recycling of
electrical and electronic devices. There is a symbol
on the product, the operating instructions, or the
packaging to this effect. The materials in these
items can be used again according to this marking. By reusing
old devices, materially recycling, or recycling in some other form
of old devices such as these you make an important contribution
to the protection of our environment. Please ask your city, town,
community, or county authorities for the location of the
appropriate disposal site.
Publicité
