Publicité
Charging and replacing the battery
To extend battery life, leave the robot vacuum cleaner charging on the self-emptying base
whenever not in use.
If the robot vacuum cleaner will not be used for an extended period of time, remove the
battery and store it in a safe, dry place.
To replace the battery, follow the instructions below:
1.
Unscrew the screws on the lower housing, remove the latter, and take out the
battery.
2.
Insert the new battery.
3.
Put the battery and the lower housing back in place and re-tighten the screws.
5. TROUBLESHOOTING
Robot vacuum cleaner
Problem
The robot vacuum
cleaner does not
switch on or does not
clean
The robot vacuum
cleaner isn't charging
or returning to the
self-emptying base
The robot vacuum
cleaner does not work
properly
Possible cause and solution
The robot vacuum cleaner does not work when battery is low.
Allow it to charge before operation.
The room temperature is below 0 °C or above 40 °C.
There are too many obstacles near the self-emptying base.
Relocate the base to an obstacle-free area.
Clean the charging terminals of the robot vacuum cleaner and
the self-emptying base.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the self-
emptying base. Place it closer and try again.
Turn off the robot vacuum cleaner and turn it on again.
Reset the robot vacuum cleaner by pressing the side Reset
button.
Conga 9990 AI Spin Revolution Ultra Power Home
ENGLISH
73
Publicité
