cecotec CONGA 9990 AI SPIN REVOLUTION ULTRA POWER HOME Manuel D'instructions page 71

Robot vacuum cleaner's Location function
Allows to locate the robot vacuum cleaner on the map.
4. CLEANING AND MAINTENANCE
Cleaning the main brush
The main brush spins at top speed and helps pushing the dirt into the suction mouth.
This brush is in contact with the floor, and therefore with dirt, so it can wear out overtime,
affecting negatively to the cleaning efficiency. It is therefore recommended to replace the
main brush after approximately 250 hours of use.
1. Slightly press the main brush frame's tabs to open the main brush compartment
and remove it. Fig. 11
2. Remove hair, lint, and other dirt trapped in the brush and around the shafts with
the help of the self-cleaning brush. Fig. 12
3. Clear and clean the robot vacuum cleaner's suction channel.
4. Reinstall the main brush and its frame.
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brush. Fig. 13
The side brush is designed with many bristles that push dirt into the suction mouth and
thoroughly clean edges and corners. This brush may wear out overtime, which will negatively
affect cleaning efficiency. We recommend replacing the brush every 3 months (depending on
the frequency and type of use).
Recommendation
- It is recommended to clean the side brush once a week with the help of the self-cleaning
brush.
- Remove the side brush by pulling it outwards and clean it regularly.
Mixed tank. Fig. 14:
- Remove the mixed tank.
- Empty the water tank
- Open the mixed tank cover and empty it.
- Remove the filter and filter holder as shown in Figure 14.
- Use the self-cleaning brush to clean the inside of the mixed tank.
- Reinstall the mixed tank on the robot vacuum cleaner.
Conga 9990 AI Spin Revolution Ultra Power Home
ENGLISH
71