Publicité
Assembly
Handle
The compressor handle is to be assembled as follows:
Fig. 1 and 2
1 Get the two threaded pins from the accessory bag and
put them into the threaded holes in the handle tubes.
2 Push the two handle ends into the fixing holes.
3 Tighten the screws to fix the handle in place.
Wheels, Fig. 3
1 For fixing the wheels (12), first put one axle pin through
the wheel. Then place the spacer washer to the under-
side of the wheel.
2 Fasten the wheel unit through the hole in the bracket
underneath the tank.
3 Fasten the flat washer, the split washer, and the nut.
Tighten the nut from the underside of the wheel and
attach the wheel cover.
4 Repeat the procedure for the second wheel.
Rubber feet, Fig. 4
Fix the rubber feet to the bracket on the front of the tank
using the screws, washers and nuts supplied.
Oil, Fig. 5 and 6
Warning: For the first use, the compressor must be filled with
oil
In order to prevent a possible spilling of the oil during
transport, the oil is supplied in a separate bin. It must be
filled into the tank before switching the compressor on.
Operating the machine without oil will cause irreparable
damage and render the warranty invalid.
1 Remove the plastic oil inlet plug (14) on top of the
crank box of the compressor casing.
2 Fill the oil supplied into the crank box until the oil
level in the sight glass (16) reaches the centre of the
red circle.
3 Re-attach the oil inlet plug (14) and tighten it firmly.
Air filter, Fig. 7
Warning: The air filter must be fitted before the first use.
An operation without filter damages the compressor and
renders the warranty invalid.
1 Remove the plastic air filter plug from the head of the
compressor.
2 Disassemble the filter. Remove the wing nut with washer
from the filter.
3 Remove the cover and the air filter.
4 Remove the centre fixing part and screw it into the air
inlet as firmly as possible.
international 21
Publicité
