Publicité
Set-up
Hold the light fixture
tion position. Bear in mind the drill hole in the
light fixture
through which the mains cable
2
will be inserted.
Mark three drill holes for the screws
Drill the holes. Be sure not to damage the
mains cable (external)
Insert the wall plugs
necessary, use a hammer to help you.
Guide the mains cable through the drill hole in
the light fixture
2
and attach the light to the ceiling.
Before the light is connected, the insulated
ground wiring must be prepared with an addi-
tional insulation.
Feed the mains connection cable (external)
through the included protective tubes
Note: Be sure to correctly connect the individ-
ual leads on the mains cable (external)
wire, black or brown = symbol L, neutral wire,
blue = symbol N, earth wire, green-yellow=
symbol
.
Install the plastic cover
match the cover's three notches to the correspond-
ing retaining bolts and press these upwards.
Turn the cover clockwise (right, following the
direction of the arrow) to fasten it. The adhe-
sive label with the arrow can now be removed.
Replace the fuse or switch on the circuit
breaker (I setting) inside the fuse box.
Your LED ceiling light with Bluetooth speaker is now
ready for use.
Installing the wall bracket
Install the wall bracket
trol
using the screws
9
pad
(see fig.).
24
Inserting / replacing batteries
Note: The remote control
batteries (included).
20 GB/IE
to the desired installa-
2
(see fig.).
6
.
4
into the drilled holes. If
1
provided for this purpose
.
5
4
of the light. To do this,
7
for the remote con-
22
or the adhesive
23
requires two AAA
9
Slide the battery cover (reverse) approx. 1 cm
downwards to open and then lift off the cover.
Insert two of the included AAA batteries in the
battery compartment. Ensure correct polarity.
Replace the cover and push it back to close the
battery compartment.
Your remote control
Operating the light by switch
The LED ceiling light can be switched on and
off using the wall switch. The light intensity al-
ways corresponds to the brightness level that
was last set. All other functions are controlled
4
solely via remote control
: live
Using the remote control
ATTENTION!
The functions of the remote control can only be
used after switching the LED ceiling light
with the wall switch.
Switching the light on / off
1. Switching the light on
Press the "
LED ceiling light on.
2. Switching the light off
Press the "
the LED ceiling light off.
Dimming the light
1. Increasing brightness
Press the "
the brightness. Briefly pressing this button will
gradually increase the brightness as pressed.
Holding the "
automatically increase the brightness to the
maximum.
is ready to use.
9
.
9
" button (lighting)
, to switch the
10
" button (lighting)
, to switch
11
" button Dimmer +
, to increase
12
" button Dimmer +
12
on
9
will
Publicité
