Publicité
Safety
poses a suffocation hazard. Children frequently
underestimate the dangers.
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, Styrofoam
etc. can turn into dangerous toys for children.
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
Always check the light, power supply, and mains
cable for damage before plugging it in. Never
use the light if it shows any signs of damage.
A damaged mains cable indicates a life-threat-
ening danger due to electric shock. In the event
of damage, repairs or other problems with the
light please contact the service centre or a
qualified electrician.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation, verify that the mains voltage
on site corresponds with the operating voltage
required for the light (see "Technical data").
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
Prevent fire and
injury hazards
Check the light for damage immediately after
unpacking. Contact the service centre if you
find any damage.
CAUTION! RISK OF BURNS
DUE TO HOT SURFACES!
Ensure that the light has been switched off and
has cooled before touching it, to avoid burn
18 GB/IE
injuries. Lamps develop a lot of heat in the area
of the lamp head.
The illuminant in this light must be replaced by
the manufacturer or an authorised technician
or a similarly qualified person.
This light can be dimmed using a remote control.
Do not look directly into the light source (light
bulb, LED etc.).
Do not use optical instruments to look at the
light source (e.g. magnifying glass).
Safe working
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare the installation and allow
sufficient time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive when working! Always pay
attention to what you are doing and act with
common sense. Never install the light if you are
having difficulty concentrating or do not feel well.
Safety instructions for
batteries / rechargeable
batteries
DANGER TO LIFE!
Keep batteries / rechargeable batteries out of
reach of children. If accidentally swallowed
seek immediate medical attention.
DANGER OF EXPLOSION!
Never recharge non-rechargeable batteries.
Do not short-circuit batteries / rechargeable
batteries and / or open them. Overheating, fire
or bursting can be the result.
Never throw batteries / rechargeable batteries
into fire or water.
Do not exert mechanical loads to batteries /
rechargeable batteries.
Publicité
