Publicité
Risk of leakage of batteries / rechargeable
batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries /
rechargeable batteries, e.g. radiators / direct
sunlight.
If batteries / rechargeable batteries have leaked,
avoid contact with skin, eyes and mucous mem-
branes with the chemicals! Flush immediately
the affected areas with fresh water and seek
medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries / rechargeable
batteries can cause burns on contact with the
skin. Wear suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of batteries / recharge-
able batteries, immediately remove them from
the product to prevent damage.
Only use the same type of batteries / recharge-
able batteries. Do not mix used and new bat-
teries / rechargeable batteries.
Remove batteries / rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery / recharge-
able battery!
Insert batteries / rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery /
rechargeable battery and the product.
Clean the contacts on the battery / rechargea-
ble battery and in the battery compartment
before inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
Safety / Preparation / Prior to installation / Set-up
of the material is determined by the individual local
conditions.
- Pencil / marking tool
- 2-pole circuit tester
- Screwdriver
- Electric drill
- Drill bit (approx. ø 6 mm)
- Hammer
- Side cutter
- Ladder
Prior to installation
Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations.
This person must be familiar with the properties of
the light and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the
light itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Check that the power is off using a 2-pole cir-
cuit tester.
Unpack the LED ceiling light and place it on a
non-slip base. (Be careful not to scratch it).
Apply light pressure to the plastic cover
with both hands. While pressing on it, turn the
plastic cover
direction of the arrow) as far as it will go and
remove the plastic cover
Set-up
Installing the light
Before installation, ensure that the circuit to
which the light will be connected is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 setting).
anti-clockwise (in the opposite
7
by lifting it up.
7
7
GB/IE
19
Publicité
