Connecting The Peripheral Drive Cable - Star TSP700 Série Mode D'emploi

1 Install the ferrite core onto the peripheral drive cable as shown in the
illustration.
2 Pass the fastener through the holes in the ferrite core as shown in the
illustration.
3 Loop the fastener around the cable, and then pull the end of the fastener tightly
through its buckle. Use a pair of scissors to cut off the excess end of the
fastener.

Connecting the peripheral drive cable

Connect the peripheral drive cable to the connector on the printer. Then, connect
the other end of the cable to the peripheral drive circuit.
EU only
10cm
( Maximum )
EU only
EU only
For EU
– 103 –
Ethernet cable
Ferrite core
(EU only)
Fastener
Except for EU