Star TSP700 Série Mode D'emploi page 103

I DIP Switch (for E type)
Switch
3-1
3-2
3-3
3-4
Change DIP Switch 3-2 to ON to initialize the setting information when the power
is turned on. Change DIP Switch 3-4 to ON to use either the STAR recommended
printer driver OPOS or Java POS.
The factory settings of DIP switch are all OFF.
The interface firmware must be ver.2.01 or later.
I Initializing Settings (for E2 type)
Set the push switch as described below to initialize the setting information.
Push the switch for one to five seconds while running under normal operating
mode. The green and red LEDs will flash with a regular pattern. After that, push
the switch once again in that state to turn OFF both of the red and green LEDs.
This will return the settings of the interface board to their default, or ex-factory,
settings. After the interface board has been initialized, the printer will automati-
cally reboot itself.
I LED Display
Green : Lights when other party connection is recognized as 10BASE-T (for E
type) or 100BASE-TX (for E2 type).
Red : Lights when packets are received.
I LPR Port Driver
To use from Windows NT4/2000/XP, use a standard Windows standard LPR port
driver set.
For Windows XP/2000
Add a "Standard TCP/IP port".
This driver allows the use of both "Raw" and "LPR" protocols.
"LPR" is recommended for normal use.
To use LPR, set the following.
Key Name: 1p
Enable LPR Byte Count: Enable
I Printer Driver / Utility software
The printer driver and utility software can be downloaded from the following
website.
Printer Driver URL : http://www.star-m.jp/eng/dl/dl02.htm
Note: Print on the printer after setting the board's IP address using the fixed
address by NV registration, or using DHCP/BOOTP, RARP.
Function
Always OFF
Initialization of settings
Always OFF
#9100 Multi-session
(Maximum 8 sessions)
– 100 –
ON OFF
Should be set to off
Valid Invalid
Should be set to off
Valid Invalid