Star TSP700 Série Mode D'emploi page 19

Note 2: When using paper with a thick-
ness which does not require the use of
the tension bar (100 µ m paper thick-
ness 150 µ m), remove the tension bar
unit by removing the clips at both ends
of the bar with a flat head screwdriver.
Then, lower the right and left adjust-
ment levers by unhooking them with a
flat head screwdriver first, then lower-
ing them to the proper position.
Ordinarily, your dealer should have
already done these procedures.
When using a paper roll with an 82.5 mm
width, be sure to remove the paper roll
holder. Then, change the setting for
memory switch 4 to change the print
width from 72 mm to 80 mm.
For instructions on setting the memory
switch, please refer to the separate Pro-
grammer's Manual.
When using a paper roll with a 57.5 mm
width, install the paper roll holder in
the groove in the printer. Then, change
the setting for memory switch 4 to
change the print width from 72 mm to
52.5 mm or 50.8 mm.
For instructions on setting the memory
switch, please refer to the separate Pro-
grammer's Manual.
Note: If a paper roll with a 57.5 mm
Paper roll holder
width has been used, a paper roll with a
79.5 mm or 82.5 mm width cannot be
used. (Changing from the smaller roll
to a larger roll will cause part of the
print head to rub against the platen and
deteriorate.)
– 16 –