Télécharger Imprimer la page

BWT PERLA PRO XXL Notice Originale page 45

Publicité

CONNECTION OF THE BRINE REGULATOR
The brine regulator is located in the brine tank (grey PVC cylinder) inside the salt tank.
It is advisable to connect the flexible white pipe supplied Ø 11x14 to the controller and then connect the other
end to the brine suction opening while placing the installation accessories and the isolation valve provided
between the hydraulic control unit and the pipe as in diagram below.
nipple M/M
Valve 3/8''
connection 3/8'' - 11/14
Mounting 1 tank
BRINE REGULATOR ADJUSTMENT
Remove the regulator from the brine well placed in the salt tank.
Check dimension "X" as on diagram below. Adjust it if necessary by sliding the float on the regulator rod.
Type
150
300
400
600
800
1250
SALT TANK PREPARATION
Load the brine tank. Do not exceed the top of the chimney so that the brine valve is accessible. Make sure that
the floor and any supports are correctly positioned.
CAUTION :
It is imperative to inspect the inside of the brine tank. In some cases it is observed the creation
of a vault of salt which makes think that the salt loading is correct. Regularly check that the salt on the top
is not set in mass.
COMMISSIONING
tubing 11/14
to brine tank
Brine regulator
80mm
1
2
3
4
5
Side «X» in millimeters
standard
Maximum
406
418
484
435
486
545
445
457
390
410
445
457
Technical manual BWT PERLA PRO XXL - code P0011058 - Rev 10 - 23/11/2021
tubing
nipple M/M
Valve 3/8''
11/14
connection 3/8'' - 11/14
Mounting 2 tanks
Brine weel
Floor
Plastic cap to remove (see diagram)
standard
nil
1 - 2 - 3 - 4
1 - 2 - 3
nil
1 - 2
nil
injector
n°2 PVC
plug
maximum
1 - 2
1 - 2 - 3 - 4 - 5
1 - 2 - 3 - 4 - 5
1 - 2
1 - 2 - 3 - 4 - 5
1 - 2 (by salt tank)
45

Publicité

loading