Publicité
Thank you for your trust in BWT by purchasing this softener.
IMPORTANT :
before any hydraulic or electrical connection, commissioning, use or maintenance, please
read carefully this manual. The non-compliance with its instructions may void warranty.
USE
This device is not designed for treating non-drinking water. Therefore, if it delivers drinking water, it must
exclusively be connected to a water supply already in compliance with the requirements set by the applicable
standards.
UNPACKING
Check that the device and its packing have not been damaged during transportation. Do not use the device in
case of any visible damage, and contact the vendor.
LOCATION
The device location shall be:
- flat, clean, dry, properly ventilated and not accessible to unauthorized persons.
- protected from bad weather, heat sources and chemical product vapors.
INTERVENTIONS
The owner of the appliance holds the responsibility for making sure that any installation, care or maintenance
work is carried out by a duly authorized person, with proper skills and tools, and fully aware of this manual
content.
The work shall be performed according to the state of art and the standards applicable in the room where the
device is installed, especially regarding plumbing, electricity and handling of chemical products (see here-below).
PLUMBING
It is especially important to fit efficient water-hammer arresters if the softener input and/or output are connec-
ted to devices likely to generate water-hammer effects (for example, solenoid valves).
ELECTRICAL CONNECTION
Avoid any intermediate connecting device (extension cord, power strip) between the device and the wall outlet.
Check the circuit compliance towards all applicable electricity standards, especially regarding electrical groun-
ding as well as electrical safety.
Do not try to connect the device if its power supply wire is damaged. Please contact the vendor in order to
get a new complete set of wire + transformer.
Before plugging the device to the wall outlet, cut off the power on this outlet by using the concerned circuit
breaker or by removing the concerned fuse.
If the device is installed close to any equipment with high electromagnetic parasites emissions (such as a high
power transformer), it is necessary to reinforce its standard protection towards usual parasites by the proper
parasite arrester system and a shielded wire.
Do not open the electrical controller of the device without the proper qualification. Electrocution hazard.
REQUIREMENTS FOR USE
Technical manual BWT PERLA PRO XXL - code P0011058 - Rev 10 - 23/11/2021
27
Publicité
