Publicité
CHEMICAL PRODUCTS HANDLING
Chemicals may be necessary for certain servicing operations. The user shall be fully aware of any hazard invol-
ved in those and use the proper personal or collective protective equipment accordingly.
The unit's surfaces must not be cleaned with any alcohol or alcohol-based product, nor with any product
containing plastic solvents.
INTEGRITY OF THE DEVICE
The unit must not be modified or tuned without the manufacturer's prior written approval.
APPLICABLE STANDARDS
This device is in compliance with:
- Directive 2014/30/UE on electromagnetic compatibility.
- Directive 2014/35/UE on electrical equipment intended for use within certain voltage limits.
- Directive 2006/42/UC dated 17/05/2006 on machinery, and amending Directive 98/37/EC
- Directive RED 2014/53/UE making radio equipment available on the market.
- Directive 2011/65/UE dated 08/06/2011 on the restriction of the use of certain hazardous substances
in electrical and electronic equipment, amending Directive 2002/95/EC
- This product is subject to Directive 2014/68 / EU of 15/05/2014 relating to pressure equipment. It meets
the requirements of Article 4 point 3 (design and manufacture in the state of the art in use) but does
not fall into categories I to IV and, as such, is not concerned by the CE marking for pressure equipment.
- Protection against pollution of potable water in water installations and general requirements of devices
to prevent pollution by backflow (In accordance with the legislation in force).
- EN 973 standard for sodium chloride type A for the regeneration of ion exchangers used to soften
drinking water.
- The acoustic pressure level is below 70 dB.
- [garbage bin pictogram] this symbol proves that the device complies with the European
Directive on Waste Electronic and Electrical Equipment (WEEE): electrical and electronic
components shall be separately thrown to proper trash bins, and their disposal, compliant
with instructions, will support the reduction of bad consequences as well as possible hazards
towards environment and human health.
The warranty complies with the local laws of the country where the device is sold, with possible add-ons
provided by its brand.
Please look for details on the website of your brand vendor, most of the time on the pages dealing with Service.
The warranty is voided in the following cases:
- installation on non-drinking water
- non compliance with the requirements of this chapter
- non compliance with the installation instructions (see § INSTALLATION PROCEDURE)
- non compliance with the maintenance instructions (see § ROUTINE & ADVANCED MAINTENANCE)
- non compliance with environmental specifications (see § TECHNICAL FEATURES)
Technical manual BWT PERLA PRO XXL - code P0011058 - Rev 10 - 23/11/2021
28
WARRANTY
Publicité
