Publicité
iNSTALLATiON
installation
9.2
Factory settings
The appliances are delivered pre-prepared:
- Electrical connection from above; installation on unfinished
walls
- Switching jumpers for 8.8 kW connection
- Water connection on unfinished walls
10. Installation
Note
f Mount the appliance on the wall. The wall must have
f
a sufficient load-bearing capacity.
This chapter describes installations in accordance with the factory
settings.
For further installation options, see chapter „Alternative instal-
lation methods".
f Undo the cover fixing screw by two turns.
f
f Remove the appliance front cover towards the front.
f
1 Power supply from above
2 Water connection on unfinished walls
f Cleanly cut or break out the required entries in the appliance
f
back panel. If necessary, use a file.
6
| DHA 4-8 L
f Mark out the holes for drilling using the installation template.
f
f Drill the holes and insert suitable rawl plugs.
f
Note:
DHA appliance. Use the large washer supplied for the upper hole.
f Tighten the two fixing screws to the correct insertion depth.
f
f Prepare the power cable.
f
1
2
f Insert both connectors. Observe the insertion depth.
f
f Cut an opening in the cable grommet suitable for the select-
f
ed power cable.
4,5 - 5,5
The existing drill holes can be used when replacing a
115
46 - 50
4 x 35
6,0
50
www.stiebel-eltron.com
Publicité
