SilverCrest SGS 100 B1 Instructions D'utilisation Et Consignes De Sécurité page 12

Switching the product on/off: Turn the power/
steam control 6 to one of these positions:
Position
0
1
2
Position 2 must not be used with
the nose steamer 2
NOTE: The steam is being generated now .
Depending on the amount of water and on the
steam setting, it may take up to 10 minutes to
form sufficient steam .
Close your eyes and hold your face/nose over
the selected steamer 1 2 (fig . D, E) .
NOTE: The closer you place your face or nose
to the face steamer 1 or nose steamer 2
respectively, the more intensive the steam . Move
back a little if the steam should become too
intensive .
When using the face steamer 1 : The
steam quantity can be manually adjusted with the
pin 12:
Position
MIN
MAX
(The MIN and MAX indicators 10 are
marked on the rear of the base unit 8 )
Switch the product off when you are
finished: Turn the power/steam control 6 to
the 0 position .
12 GB/IE/NI
Action
LED 7
Product off
Low steam
High steam
Action
Low steam
High steam
NOTE: For safety reasons, the product
automatically switches off when the water in the
water container 5 has evaporated . If you want
to continue using the product, disconnect the
Off
power plug 9 from the socket outlet .
On
Let the product cool down, before using it again .
On
˜ Disassembly
m
WARNING! Risk of injury through
burning/scalding! Do not move the product
while it is in operation or cooling down .
Disconnect the power plug 9 from the socket
outlet .
Hold the base unit 8 and turn the steamer
1 2 anti-clockwise to unlock it . Remove the
steamer from the base unit .
If applicable, remove the aroma reservoir lid 3 .
Dispose of the contents in the aroma reservoir
1 4 .
˜ Cleaning and care
m
DANGER! Risk of electric shock! Before
cleaning the product: Always disconnect the
power plug 9 from the wall outlet .
m
WARNING! Never immerse the product in
water or other liquids . Never hold the product
under running water .
m
ATTENTION: After use, the product should be
cleaned to avoid the accumulation of grease and
other residues .
Wipe down the base unit 8 and the water
container 5 with a slightly damp cloth .
Do not let any water or other liquids enter the
base unit's 8 interior .
Do not use any abrasive, aggressive cleaners or
hard brushes to clean the product .