SilverCrest SGS 100 B1 Instructions D'utilisation Et Consignes De Sécurité page 10

ATTENTION! Risk of
product damage! Do not add
any additives, like oil, to the water
container . After the water has
evaporated, these additives may
burn and damage the product .
Setup instructions
Always operate the product on
an even, stable, heat-resistant,
clean and dry surface .
Fire/burn hazard and heat
m DANGER! Risk of fire! Never
leave the product unattended
while it is plugged in .
m DANGER! Risk of fire! Never
heat the product if it does not
contain water .
m WARNING! Risk of injury
through burning/scalding!
Do not touch the hot inner parts
of the product . The water is
boiling in the water container
during operation .
10 GB/IE/NI
ATTENTION! Risk of
product damage! Do not
place the product on or near heat
sources or open fire .
Allow the product and all its parts
to cool down before transporting
or cleaning it .
Do not move the product while it
is in operation or cooling down .
Remove make-up and care
products from your face before
steaming .
Cleaning
Disconnect the product from the
wall outlet during periods of
disuse and before cleaning .
After use, the product should
be cleaned to avoid the
accumulation of grease and other
residues .
˜ Before first use
Remove all packaging materials .
Clean the product and its accessories (see
"Cleaning and care") .
˜ Preparation
The product can be used either with the face
steamer 1 or the nose steamer 2 .
Always operate the product on an even, stable,
heat-resistant, clean and dry surface .