Publicité
♦
Place the rivet body in the drill hole .
♦
Slide the appliance over the rivet
mandrel is fully inserted into the mouthpiece
♦
Pull the trigger
. The mandrel is pulled into
the device, detached from the rivet body and
the rivet joint is established permanently . The
mandrel falls into the pin collector
If necessary, repeat the process until the man-
drel has been fully separated from the rivet
body .
♦
Proceed in the same way with the other rivets
.
♦
Empty the pin collector
♦
When you have finished working, disconnect
the appliance from the compressed air source .
Maintenance and cleaning
WARNING! RISK OF INJURY! Discon-
nect the
appliance from the compressed air
supply.
CAUTION!
►
Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the appliance .
Avoid all skin contact with these substances .
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis .
►
The dust and vapours produced by using
the appliance can be hazardous to health
(e .g . cause cancer, birth defects, asthma
and/or dermatitis); it is essential to carry out
a risk assessment in respect of these risks
and to implement corresponding regulatory
mechanisms .
NOTE
To ensure correct functioning and long-term
durability of the rivet gun, pay attention to the
following points:
■
Sufficient and continuously intact oil lubrication
is highly important for optimum functioning .
■
8
│
GB │ IE │ NI
until the
.
.
regularly .
■
Use only the genuine replacement parts rec-
ommended by the manufacturer, otherwise you
could put users at danger . In doubt, contact the
Service Centre .
■
Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of the rivet gun .
■
Only clean the appliance with a soft, dry cloth
or with compressed air .
■
Never use sharp or scratchy cleaning agents
under any circumstances .
Changing the gripper jaws
Friction can wear out the gripper jaws
happens, replace the worn gripper jaws
the supplied spare gripper jaws
♦
Unscrew the front connector
sembly spanner
,
if necessary . This gives you access to the follow-
ing parts:
A B
C
E
A
Appliance shaft
B
Lock nut
C
Lock washer
E
Two-piece metal cone
G
Gripper jaws
♦
Unscrew the two-piece metal cone (E) holding
the gripper jaws (G) from the shaft (A), using
the two assembly spanners
sary .
. If this
with
as follows .
using the as-
G
and
if neces-
PDBNP 14 A1
Publicité
