Dreame DreameBot W10 Manuel D'utilisation page 9

How to Use
EN
3. Place the robot onto the base
4. Start mopping
Press briey the button. The robot starts rom the base and mops the house
based on the optimal cleaning plan scheduled by the map.
Note:
· If the robot is not on the base, please put it back before starting it.
· The robot will clean the mop pad before cleaning, please wait patiently until the
mop pad is cleaned.
· Do not manually move the base, fresh tank, waste tank, or washboard while mopping.
14
5. Return to sel-clean
While mopping, the robot will return to the base to have the mop pad cleaned
as cleaning conditions set in the app. The robot resumes cleaning ater the
mop pad is cleaned.
6. Clean the mop pad
Ater the robot completes cleaning and returns to charge, the base starts
cleaning and drying the mop pad.
Note:
· To clean the mop pad at any time, press and hold the button on the base for 3
seconds to start cleaning.
· While cleaning the mop pad, i the water in the resh tank is insufcient or the waste tank
is ull, the robot will send a voice prompt, or the app will send a notication.
· After the robot completes mopping, clean the waste tank in time to avoid mold or odor.
It is recommended to change the mop pad every 1 to 3 months.
How to Use
Functions in APP
1. Map management
The homepage o the app displays the current map. On this page, No-Go
Zone allows you to set zones to be avoided, and Map Management allows
you to modiy the current map .
2. Cleaning mode settings
Cleaning Mode on the homepage allows you to change the cleaning mode,
the suction power, as well as the humidity o the mop pad.
3. Sel-cleaning settings
Sel-Cleaning Settings on the homepage allows you to change the requency
or sel-cleaning and manually start a mop pad cleaning task or manually
start or end a mop pad drying task.
4. Product settings
The Settings page allows you to enable or disable device unctions, congure
scheduled cleanup, or view cleaning history and device inormation.
Note:
· A map must be created before you use the room- or zone-based cleaning, and
manage maps.
· For more information about functions, check the corresponding interfaces or
guides in the app.
· The version of the app might have been updated, please follow the instructions
based on the current app version.
Routine Maintenance
Parts
For optimal perormance, ollow the instructions below to clean and maintain
the robot and base.
Part Maintenance Frequency Replacement Frequency
Dust Bin Clean it as needed /
Dust Bin Filter Once every 2 weeks Every 3 to 6 months
Fresh Tank Once every 2 weeks /
Fresh Tank Filter Media Once every 2 weeks /
Waste Tank Ater each use /
Washboard Once every 2 weeks /
Main Brush Once every 2 weeks Every 6 to 12 months
Side Brush Once every 2 weeks Every 3 to 6 months
Mop Pad Once every month Every 1 to 3 months
Universal Wheel Once every month /
Auxiliary Wheel Once every month /
LDS Laser Sensor Once every month /
Return-to-Base Sensor Once every month /
Cli Sensors Once every month /
Signaling Area on Base Once every month /
Overow Sensors on Base Once every month /
Charging Contacts on Robot Once every month /
Charging Contacts on Base Once every month /
Bottom o the Robot Once every month /
Body o the Base Once every month /
Note: The replacement frequency will depend on your usage of the robot. If an
exception occurs due to special circumstances, the parts should be replaced.
EN
15