Dreame DreameBot W10 Manuel D'utilisation page 8

How to Use
EN
Turn On/O
Press and hold the button or 3 seconds to turn on the robot, and the power
indicator is permanently on. Place the robot onto the base, and the robot
turns on automatically and starts charging. To turn o the robot, move the
robot away rom the base, and press and hold the button or 3 seconds.
Fast Mapping
Remove the mop pad beore ast mapping.
Ater you connect the robot to the app, create a map as instructed in the app.
The robot moves around to scan the environment and creates a map without
cleaning. Ater the robot returns to the base, a map is created and saved
automatically.
Pause / Sleep
When the robot is cleaning, press briey any buttons on the robot or the
button on the base to pause the robot.
I the robot pauses or more than 10 minutes, it automatically enters the sleep
mode, and the power indicator and charging indicator stop glowing. Press
any buttons on the robot or base, or tap on the app to wake up the robot.
Note:
· The robot will turn o automatically i it is let in the sleep mode or more than 12 hours.
· If the robot is paused and placed onto the base, the current cleaning process will end.
12
Spot Cleaning
When the robot is not placed on the base and is on standby, press briey
the button to enable the spot cleaning mode. In this mode, the robot cleans a
square-shaped area o 1.5 × 1.5 meters around it and returns to its starting point
once the spot cleaning is completed.
1.5 m
1.5 m
Restoring Factory Settings
I the robot does not unction properly and the buttons do not respond ater
being restarted, use a pin to press the reset button or 3 seconds until you
hear a voice saying "Restoring actory settings". It will take about 5 minutes
to reset the robot to its original actory settings. Ater resetting the robot, you
must recreate maps and no-go zones.
How to Use
Sweeping Function
Note: Do not attach the mop pad while using the sweeping unction.
Method 1: Press briey the button on the base, and the robot starts
sweeping.
Method 2: Press briey the button on the robot, and the robot starts sweeping.
Note:
· Make sure that the robot is fully charged before using it. Do not manually move
the robot when it is cleaning.
· If the battery gets low while cleaning, the robot returns to the base and resumes
cleaning ater charging its battery. （ The Resume Cleaning unction must be enabled
on the app in advance.）
Cleaning Mode
Ater the robot is turned on, it cleans each room by cleaning along the
edges and walls rst and then cleaning in an S-shaped pattern. The robot
automatically returns to the base to charge its battery ater cleaning.
Mopping Function
Note: Do not use the mopping function on the carpet.
1. Attach the mop pad
2. Take out the resh tank, ll it with clean water, and then place the resh
tank into the base.
MAX
To the MAX Line
Note:
· Do not ll in hot water, otherwise the resh tank may be deormed.
· Use only the Dreame-brand multi-surace oor cleaner. Otherwise, the unctions
o the base may be aected.
EN
13