Dreame DreameBot W10 Manuel D'utilisation page 12

Routine Maintenance
EN
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts o the robot by using a sot, dry cloth:
· Cli sensors at the bottom o the robot
· Charging contacts at the back o the robot
· Return-to-base sensor at the ront o the robot
· Bumper at the ront o the robot
· LDS on the top o the robot
Cli Sensors
Bumper
Return-to-Base
Sensor
LDS
Charging Contacts
Note: Wet cloth can damage sensitive elements within the robot and base.
Please use dry cloth for cleaning.
20
Sel-Wash Base Charging Contacts and Overow
Sensor
Charging Contacts
Overow Sensor
Robot Restarting
I the robot stops responding or cannot be turned o, press and hold down
the button or 10 seconds to orceully turn it o. Then, press and hold the
button or 3 seconds to turn the robot on.
Battery
The robot contains a high-perormance lithium-ion battery pack. Make sure
that the battery remains well-charged or daily use to maintain optimal
battery perormance. I the robot is not used or an extended period o time,
turn it o and put it away. To prevent damages rom over-discharging, charge
the robot at least once every three months.
Errors
I the base does not work properly, an error icon and message will be displayed on the display screen. Read the message and handle the issue based on the
following table.
Error Icon Error Message
Insufcient Water in Fresh Tank
Fresh Tank Not Installed
Waste Tank Malunction
Washboard Not Installed
Abnormal Washboard Water Level
Robot Malunction
Solution
Add a sufcient amount o water to the resh tank.
Put the resh tank in place.
Put the waste tank in place.
Empty the wastewater.
Check whether the washboard is installed and whether the clips on both sides o
the washboard are in place.
Check whether the waste port is clogged. I yes, clean it.
Check whether an exception occurs to the robot. Please reer to the "FAQ" section
in this manual or troubleshooting.
EN
21