Scheppach SD1600V Traduction Des Instructions D'origine page 23

13. Troubleshooting
Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out
maintenance work.
Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates slightly
when the motor is running in normal
operation.
Saw blade swings out
Holders not aligned straight
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes
Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not screwed
down or is on the motor
The motor is not secured
Holders not aligned
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt to
repair the motor yourself as this should
be carried out by trained personnel.
Refer to the instructions given earlier in
this manual for information on installing
the saw
The heavier the work bench is,the less
the vibration. A bench made from ply
wood always vibrates more than one
made from solid wood. Select the work
bench best suited to your working condi-
tions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the holders
are fastenedto the arm. Align the holders
so that they are perpendicular to each
other and retighten the screws.
GB
23 / 160