SilverCrest 416131 2210 Mode D'emploi page 15

Vacuum sealing
Vacuuming the tube film
You can also suck the air out of the bag (vacuum) during welding:
NOTE
► Do not try to vacuum seal bags that contain only liquids .
► If you want to vacuum seal bags containing moist/juicy foods, make sure
that no water or moisture can get into the appliance . If small quantities
of liquid or food are accidentally sucked in, they will be deposited in the
small drip tray that is located within the lower sealing ring 5 .
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5 . The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7 . Otherwise the vacuuming and welding will not function correctly:
2) Close the appliance lid 1 . Ensure that both corners of the appliance lid 1
click closed . If necessary, press them down once again on the markings
and
■ 12 │ GB │ IE
so that the appliance lid 1 clicks into place and locks shut .
SV 125 C6