SilverCrest 416131 2210 Mode D'emploi page 13

NOTE
► The bag opening must lie flat on the sealing wire 4 . Otherwise the weld-
ing does not work properly .
4) Close the appliance lid 1 . The press seal q presses the bag onto the
sealing wire 4 to create a smooth seam . Ensure that both corners of the
appliance lid 1 click closed . If necessary, press them down once again on
the markings
locks shut .
5) Press the
process is completed, the control lamp w flashes briefly and then goes out .
NOTE
► You can halt the sealing process at any time by pressing the
again . The control lamp w flashes and then goes out .
■ 10 │ GB │ IE
and so that the appliance lid 1 clicks into place and
button w . The control lamp w lights up . As soon as the sealing
button w
SV 125 C6