SilverCrest 416131 2210 Mode D'emploi page 14

CAUTION – PROPERTY DAMAGE!
If the control lamp w does not turn off after a maximum of
10 seconds during the sealing process, the appliance is
defective!
► Remove the plug from the mains power socket immediately . Do not attempt
to repair the appliance yourself . Contact the Customer Service department .
6) Open the appliance lid 1 by pressing the lid release 8 and flipping the lid 1
upwards . Remove the bag . This is now sealed at one end .
NOTE
► Ensure that the weld seam is properly closed . A correct weld seam should
be a smooth, straight stripe without any creases .
7) Fill the bag . You must leave at least 6 cm of the bag free up to the edge to
be welded .
CAUTION – PROPERTY DAMAGE!
► Fill the bag so that no food scraps or liquids can leak out during welding
and get into the appliance .
8) If you do not want to vacuum the bag, you can now weld the other, open side .
NOTE
► Wait a few seconds to allow the appliance to cool down before sealing
the next bag .
During this cool-down phase, you cannot start the "seal" function .
SV 125 C6 GB │ IE │ 11 ■