SodaStream DUO Mode D'emploi page 17

ET UP
SODASTREAM CO
®/MD
Please note that the
SodaStream Duo is
TM/MC
compatible with the
SodaStream CO Quick
®/MD
2
Connect Cylinder and is NOT
compatible with the
SodaStream Screw System
®/MD
Cylinder.
INSTALLING THE CO
1. Place the SodaStream Duo
on a flat sturdy surface in an upright position. Turn the
carbonating flask lever to the right to the unlocked
position. The carbonating head will rise automatically.
2. The carbonating flask will open. Pull the carbonating
flask gently forward and remove the SodaStream
Glass Carafe / Plastic Carbonating Bottle if it is installed
in the SodaStream Sparkling Water Maker.
®/MD
WARNING! Never insert or replace the CO
Connect cylinder while the Glass Carafe or Plastic
Carbonating Bottle is installed in the Sparkling
Water Maker. This can cause the Glass Carafe or
Plastic Carbonating Bottle to burst.
3. Return the carbonating flask to the upright position,
push and hold the carbonating head down and turn the
carbonating flask lever left until it clicks into the locked
position.
4. Gently pull the back cover away from the Sparkling
Water Maker to remove.
5. Remove seal and cap from the SodaStream CO
Quick Connect Cylinder.
6. Raise the pink cylinder handle. Insert the CO
Connect Cylinder in the back of the Sparkling Water
Maker. WARNING! Never use the SodaStream CO
Quick Connect Cylinder if it appears to be
damaged.
7. Lower the cylinder Pink Handle.
8. Reinstall the back cover. Now you are ready to create
the bubbles.
SCREW SYSTEM CYLINDER
2
COMPATIBLE SODASTREAM
CO QUICK CONNECT CYLINDER
2
CYLINDER
2
Sparkling Water Maker
TM/MC
®/MD
Quick
2
2
Quick
2
2
NON-COMPATIBLE
®/MD
CO SCREW SYSTEM CYLINDER
2
1 2
3 4
5
7
6
Pink
Cylinder
Only
8
17