Atag WU90211RM Notice D'utilisation page 125

First steps to set up the Wi-Fi connectivity:
1. Check the "Requirements" as described above.
2. The hood and lights must be switched off.
3. Press the Wi-Fi button for three seconds. The Wi-Fi indicator will blink 3 times.
4. Press the Wi-Fi button for 3 seconds to turn on Wi-Fi. Speed level 2 and 3 indicators will blink 3
times. The Wi-Fi indicator flashes.
5. After 3 seconds it will return to the Wi-Fi-menu.
6. Simultaneously press the + (plus) and timer button to access 'Connection settings'. Speed level
2 indicator and the Wi-Fi indicator flash while connecting. This mode will turn off automatically
after 5 minutes.
7. Start the ConnectLife-app and follow the instructions in the app.
8. If the ConnectLife-app does not connect to the device, wait 10 minutes and repeat the steps
described or press the '-' (minus) button for 3 seconds to leave the Wi-Fi menu.
INFORMATION!
Troubleshoot quickly by turning the Wi-Fi module off and on again. You can find more help in the
"Wi-Fi troubleshooting" section.
Depending on the Wi-Fi state, there are 1 to 3 options available in the menu:
The Connection Setup Mode
The Pairing Mode
Remote control mode
If more than 1 option is available then use the + (plus) and - (minus) buttons to toggle between the
options.
Wi-Fi connectivity
17