SOMFY TILT&LIFT 25 WF ZIGBEE Notice page 5

Les langues disponibles

TILT&LIFT 25 WF ZIGBEE

2.2.Wiring

WARNING

• To ensure electrical safety, this Class III drive must be powered by a «SELV» voltage source (Safety Extra Low

Voltage).

• For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance.

• Improper using battery pack may cause overheat, fire, explosion, resulting in serious injury or death.

• Do not expose the drive or battery to excessive temperatures.

• There is a risk if terminals of the battery-operated drive or battery being short circuited by metal objects.

• Ensure battery is fully charged prior to installation on site.

PRECAUTION

• Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.

• Attach cables to prevent any contact with moving parts.

• Drive cable cannot be removed. If it is damaged, return the drive to the After-Sales department.

CAUTION

• Do not unplug the battery when the motor works.

• Leave the drive power supply cable accessible: the product must be easily replaceable.

• Using this drive with any products which are not listed in the attached «Compatibility matrix» document shall also

render invalid any Somfy warranty and release Somfy from any liability.

Plug the battery with the motor supply cable.

2.3.Commissioning of a Zigbee drive

In an installation with Zigbee drives, 2 solutions are available to the user: TaHoma switch solution and TaHoma ready

solution.

TaHoma switch solution is the solution in connected mode, with a TaHoma switch in the installation that allows the user to

control all his Zigbee products through the TaHoma application.

The other solution, without TaHoma switch, is called TaHoma ready. It allows the user to control his Zigbee drives only

with control points. But this installation can be switched to connected mode afterwards by adding a TaHoma switch later.

Regarding the commissioning of a Zigbee drive, it can be done in 2 different ways :

▪ Either commissioning with TaHoma pro application, which is recommended because it is easier and more complete.

▪ Either commissioning with a control point.

Please refer to the corresponding section according to the selected commissioning mode.

2.4.Commissioning with TaHoma pro application (recommended)

Commissioning with TaHoma pro application is possible and recommended for both TaHoma ready solution

and TaHoma switch solution.

2.4.1.Starting-up

A Somfypro account is required but TaHoma switch is not mandatory.

To set the drive, you need to access and use TaHoma pro application, you must have a compatible phone or mobile device

and access to the internet.