SOMFY TILT&LIFT 25 WF ZIGBEE Notice page 3

Les langues disponibles

TILT&LIFT 25 WF ZIGBEE

1.PRIOR INFORMATION

1.1.Field of application

The C25 drives are designed to motorise all types of:

▪ Interior vertical blinds which front rail moves solely by gravity with a mass less than 15 kg.

▪ Tiltable venetian blinds which bottom lath can be lifted at least by 4 cm when an upward force of 150 N is applied to

the bottom lath positioned at 16 cm from the fully extended position.

1.2.Liability

Before installing and using the drive, please read these instructions carefully.

In addition to the instructions provided in this guide, please also comply with the instructions provided in the attached Safety

instructions document.

The drive must be installed by a home motorisation and automation professional, in accordance with Somfy's

instructions and the applicable regulations in the country of installation.

Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to comply

with the instructions given in this guide and in the attached Safety instructions document, absolves Somfy of any liability and

invalidates the warranty.

After installing the drive, the installer must inform his customers of the operating and maintenance conditions for the drive

and must provide them with the operating and maintenance instructions, and the attached Safety instructions document.

Any After-Sales Service operation on the drive must be performed by a home motorisation and automation professional.

Never begin installing without first checking the compatibility of this product with the associated equipment and

accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy representative

or visit the website www.somfy.com.

Using this drive with any products which are not listed in the attached «Compatibility matrix» document shall also

render invalid any Somfy warranty and release Somfy from any liability.

2.INSTALLATION

WARNING

• These instructions are mandatory for the home motorisation and automation professional installing the drive.

• Comply with current standards and legislation in the country of installation.

CAUTION

• Never drop, knock or puncture the drive or immerse it in liquid.

• Install an individual control point for each drive.

NOTICE

Make sure that LED, programming button and input connection remain visible and easily accessible after installation.