SOMFY TILT&LIFT 25 WF ZIGBEE Notice page 10

EN
1] Press and hold the PROG button on the control point until the motorised
product moves up and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The motorised product moves up and down after a few seconds.
3] Press and hold the Up or Down button on the control point to move the
motorised product to the new desired position.
4] Briefly press the my and Down buttons simultaneously on the control point :
ð The motorised product moves up and down.
5] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
2.5.8.2. Readjusting the lower end limit
NOTICE
Keep the control point close to the drive during the whole procedure.
1] Press and hold the PROG button on the control point until the motorised
product moves up and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The motorised product moves up and down after a few seconds.
3] Press and hold the Up or Down button on the control point to move the
motorised product to the new desired position.
4] Briefly press the Up and my buttons simultaneously on the control point :
ð The motorised product moves up and down.
5] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
2.5.8.3. Readjusting the two end limits
NOTICE
Keep the control point close to the drive during the whole procedure.
10
©
Copyright 2023 - 2024 SOMFY ACTIVITES SA. All rights reserved.
TILT&LIFT 25 WF ZIGBEE
1] 2]
3] 4]
5]
1] 2]
3] 4]
5]