Publicité
Les langues disponibles
Les langues disponibles
TILT&LIFT 25 WF ZIGBEE
1] Press and hold the PROG button on the control point until the motorised
product moves up and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The motorised product moves up and down after a few seconds.
3] Press and hold the Up or Down button on the control point to move the
motorised product to the new desired upper position.
4] Briefly press the my and Down buttons simultaneously on the control point :
ð The motorised product moves up and down.
ð The upper end limit is readjusted.
5] Press and hold the Up or Down button on the control point to move the
motorised product to the new desired lower position.
6] Briefly press the Up and my buttons simultaneously on the control point :
ð The motorised product moves up and down.
ð The lower end limit is readjusted.
7] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
2.5.9.Advanced settings
Some advanced settings such as adjusting the speed or the tilting travel cannot be made with a control point.
These advanced settings can only be made via the TaHoma pro application, please refer to chapter Commissionning with
TaHoma pro application (recommended).
2.6.Tips and advice on installation
2.6.1.Questions about the product?
Observations
The motorised product is noisy.
©
Copyright
2023 - 2024 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
The wheel and the crown are not
adapted to the used tube.
The mechanical plays between drive,
accessories, tube and end of tube are
too high.
The wheel is not properly fixed to the
tube.
The equipment is constrained between
the brackets.
The length of the notch is not adapted
to the drive hook or to the used crown.
Debris, screws or other are in the tube. Empty the tube.
The temperature of the environment is
not in conformity with the operating
temperature.
1]
2]
3]
4]
5]
6]
7]
Solutions
Change the wheel and the crown.
The mechanical plays between drive,
accessories, tube and end of tube must
be decreased to the minimum.
Fix the wheel properly to the tube.
Decrease the constraint between the
brackets.
Adapt the length of the notch to the
drive hook or to the used crown.
Change the environment temperature.
EN
11
Publicité
