Roco 40420 Mode D'emploi page 9

Note: In spite of the increasingly miniaturized designs of all the elements, the installation of this lighting
set, with its width of 11.5mm and maximum height (incl. decoder) of 10mm, can reach the limits of certain
cars, especially in terms of the height. In such cases, it is absolutely necessary to produce corresponding
cut-outs on the housing of the car. Depending on the tools used, you must always note potential sources
of injury (wear protective glasses!) and make sure that the stability of the car construction is not signif-
icantly weakened (the housings and roofs are not available as replacement parts!). If you cannot find a
hole or opening for the connection wires in the wagon, then a corresponding hole can be drilled using a
1.5mm drill bit. Make sure when determining the position of such a hole that the bogies are still able to
move freely in the required turning range and that their kinematics are not hindered!
8040420921 IV_2024.indd 9 8040420921 IV_2024.indd 9
GB
9
09.04.2024 12:30:33 09.04.2024 12:30:33