Commencing Operation; Assembly The Dust Skirt; Attaching Dust Containment; Instructions For Electrical Connenction - Kunzle & Tasin Bona FlexiSand 1.9 Manuel D'utilisation

Commencing Operation

Assembling the dust skirt
Place the dust skirt in the intended notch on the rubber strip.
Never use the dust skirt when oiling. Always remove
the skirt when transporting the machine.

Attaching dust containment

Attach the dust containment hose to the dust tube on the
Bona FlexiSand 1.9.
®
If using Bona DCS , connect DCS
® TM
The air flow on the vacuum should be at least 245m
Instructions for electrical connection
This machine only operates
with the voltage and frequency
shown on the machine data
plate. Before connecting the
cable to the power supply
ensure the correct voltage and
frequency are available.
cuff to dust tube.
TM
/h.
3
DO NOT expose the machine
to rain. This machine is
intended for dry use only.
Keep the machine in a dry
building and DO NOT use it in
damp or wet places.
Bona FlexiSand 1.9 Manual
If the machine is not
connected correctly to the
electricity network, death due
to electrocution may occur.
To prevent electric shocks
always use a grounded three
wire electrical system. For
maximum protection against
electric shocks use a circuit
protected with a di erential
cut-out switch.
11
EN