Dogtra E-FENCE 3500 Manuel Du Propriétaire page 8

CHARGING THE RECEIVER/COLLAR
Recharge the unit if :
1. The LED indicator light on the receiver/collar is emitting a red color.
2. The indicator light on the receiver will not come on.
3. The indicator light on the receiver comes on momentarily, but will not stay on
near the wire.
Battery Charging Procedure
1. Attach the charging cables to the receiver as shown.
2. Plug the charger into a 220-volt wall outlet.
When properly plugged in, all indicator lights should glow red.
During the charging process, the unit will shut off.
3. The Lithium-Polymer battery is fully charged within 2 hours.
The lights will stay red during the charging process.
The red light will change into a steady green light when the battery is fully
charged. (When you disconnect the charger after finishing the charge, you
will need to restart the units).
4. After charging, cover the battery charging receptacle with the rubber plug on
the receiver/collar.
Note : Only use Dogtra-approved batteries, chargers, and accessories for the
E-Fence 3500. Unauthorized chargers may cause the unit to malfunction and the
indicator light to blink in an amber color.
Charger Info
Manufacturer : E-SUN
Manufacturing country : CHINA
Model name : MKC-0501000S, MKC-2500500S
INPUT : 100-240V~50/60Hz 0.4A
OUTPUT : 5V 1000mA, 25V 500mA
Attention!
During battery charging, the unit must be close to the wall outlet and the wall
outlet must be easily accessible for security reasons.
14
Dogtra uses Lithium-Polymer
batteries.
1. Charge the unit before using the unit
for the first time.
2. Do not charge the batteries near any
flammable substances.
3. Fully charge the batteries if the unit is
to be stored without use for a period
of 3 months or more.
HOW TO CHANGE THE LENGTH OF THE CONTACT
POINTS
The Dogtra E-Fence 3500 comes equipped with standard 15 mm contact points
that can be extended to 19 mm contact points, for use with dogs with longer
coats. To increase the contact point length from 15 mm to 19 mm, follow the steps
below.
1. Using the included adjustment tool with the side marked 5/8, unscrew the
contact points counter-clockwise.
2. Place the contact point extension over the exposed threads, flat side down.
3. Place the contact points over the extensions and tighten the contact points
and extensions clockwise using the adjustment tool with the side marked 3/4.
Caution : Tighten until firmly in place. Be careful not to over tighten.
To shorten the contact points back to the standard 5/8", start with the
adjustment tool with the side marked 3/4", remove the contact point extensions,
and tighten the contact points with the adjustment tool with the side marked
5/8".
15