Dogtra E-FENCE 3500 Manuel Du Propriétaire page 5

Boundary Wire Continuity Light
Wire Connector Tabs
be buried into the ground or wrapped around a water pipe and secured with
electrical tape.
8
When the wires are connected
properly, the boundary wire continuity
light will be on. In the event that
the E-Fence 3500 wire becomes
damaged or disconnected, the light will
automatically turn off and the warning
beep will sound.
The easy-to-use push-release wire
connectors let you instantly connect
or disconnect the boundary wire leads.
Wires should have the plastic coating
stripped approximately 1 cm before
being inserted into the red connectors
on the bottom of the wall mount
transmitter. The system comes with a
ground wire to ground the unit. Strip
about 1 cm on each end of the ground
wire and insert one end into the black
connector on the bottom of the wall
transmitter. The other end should
Power Jack
Wall-Mount Transmitter
Use the (2) included screws to mount the transmitter to a wall
securely near an outlet. The unit will withstand freezing temperatures, but it is
not waterproof. Therefore, we recommend mounting the transmitter in a safe,
dry sheltered area such as a shed, garage or carport. Plastic anchors have been
provided to secure mounting onto drywall. Use a 1/4" drill bit to make holes into
the drywall. Insert the anchors into the holes so that the open end faces out and
mount the transmitter by inserting the screws into the open end of the anchors.
To power the wall transmitter, plug the power adaptor into a standard 220-volt
outlet and connect it to the power jack of the transmitter.
Plug the 220-volt adaptor into a 220-
volt wall outlet and insert the adaptor
plug into the power jack of the
transmitter.
9