Dogtra E-FENCE 3500 Manuel Du Propriétaire page 7

PROPER FIT
The collar should be fitted so that the surgical stainless steel contact points press
firmly against the dog's skin. You should be able to fit a finger in between the
contact point and your dog's skin. The best location is either side of the dog's
windpipe.
IMPROPER FIT
A loose fit can allow the collar to move around on the dog's neck. When this
happens, the contact points may rub the skin and cause irritation. If the collar
is too loose, electrical contact will be inconsistent and your corrections will be
inconsistent also.
Dogtra uses surgical stainless steel contact points and Anti-microbial plastic to
protect the dog's skin.
Attention!
Leaving the receiver/collar in the same location on the dog's neck for an
extended period of time can cause skin irritation. If the dog is to wear the
e-collar for long periods, occasionally reposition the collar so that the contact
points are moved to a different location on the dog's neck. Make sure you
check for skin irritation each time you use the unit.
12
Receiver/Collar Battery Charging Receptacle
Adaptor
Transmitter
Adaptor
(24Volt 500mA)
The battery charger is designed for a 220-volt wall outlet.
On the inside of the receiver/collar, next
to the collar strap, is a battery charging
receptacle with a rubber plug.
The unit will be fully waterproof with
or without the rubber plug. If the dog
was in salt-water, be sure to rinse the
receiver and charging port with clean
water, and let air dry.
Receiver Adaptor
(5Volt 1A)
13