Dogtra E-FENCE 3500 Manuel Du Propriétaire page 4

DESCRIPTION OF TRANSMITTER PARTS
On/Off
Indicator Light
On/Off & Function
Selection Switch
Power Jack
E-FENCE 3500
Transmitter
6
Boundary Wire
Continuity Light
Field Width
Adjustment Knob
Connector for
Ground Wire
Boundary Wire Connector Tabs
On/Off & Function Selection Switch
Field Width Adjustment Knob
On/Off Indicator Light
The On/Off & function selection switch
has three functions. When the toggle
switch is in the up position, the unit
will give the dog a pager/vibration
followed by stimulation correction.
When the toggle switch is in the down
position, only a pager/vibration occurs
(no stimulation).
The power is off when the toggle
switch is set to the middle position.
This knob controls the width of the
signal field (the approximate distance
from the boundary wire to the location
where the receiver/collar first activates).
Turning the knob clockwise increases
the field width, giving your dog a wider
area before the activation begins.
Turning it counter-clockwise decreases
the signal field, thus giving the dog a
shorter area prior to activation.
When the On/Off & function selection
switch is either in the up or down
position the On/Off indicator light will
be on, indicating that the power is
on. When the switch is in the middle
position the light goes off, indicating
that the power is off.
The indicator light stays on even if a
fuse is blown.
7