Dogtra E-FENCE 3500 Manuel Du Propriétaire page 13

WIRE SPLICING
The wire connection must be waterproof
center hole empty. A pair of pliers should be used to gently press down and snap
together the top of the blue part of the splice.
Loop goes around yard and connects
Loop
Incorrect
Twisted
wire
House
Transmitter
Incorrect Neutral Zone Wire
Splicing
24
Do not use electrical tape, or
soldered/twisted wire nuts in this
type of connection as it will cause an
intermittent signal or disarm the system.
The waterproof splices included in
he E-Fence 3500 system are designed
to provide a sealed connection between
the wires. The insulation on the
boundary wire should not be stripped
before placing wire into the holes.
To use the waterproof splices, boundary
wire is placed into the outer holes
of the splices. This should leave the
Boucle faisant le tour du terrain
20 cm
Loop
Correct
Twisted
wire
House
Transmitter
Correct Neutral Zone Wire
Splicing
Connecting the Fence Wire to the Transmitter
wire is not damaged.
The Signal Field
The Field Width Adjustment Knob on the transmitter controls the signal field
width. Increasing or decreasing the signal field width does not affect the
stimulation intensity. To test the signal field, walk slowly toward the boundary
wire holding the receiver/collar at approximately the height of the dog's neck.
The contact points must be upward with the test light attached. Watch for the
test lamp to illuminate as this will give you an idea of the width of the signal
field. The most common and desirable signal strength will be found by setting
the system in the green/yellow zone, which creates a 60 - 180 cm signal area.
Yellow
Green
MIN
Field Width Adjustment Knob
Splice the two ends of the twisted wire
to each of the two ends of the fence
wire. Drill a hole through the exterior
wall or window/door sill or run the
fence wire through an existing utility
line hole. Connect the twisted fence
wire to the transmitter, either wire to
either terminal (wire ends must be
stripped 1 cm), and a red indicator light
should appear indicating a continuous
fence wire field. If no light appears,
check to make sure that all fence wires
are properly connected and that the
Orange
Red
MAX
25