Display; Main Display; Header; Central Value - SystemAir TControl POD glass EC Manuel D'installation Et De Maintenance

6 TControl POD glass EC

6. DISPLAY

6.1. MAIN DISPLAY

The main screen is divided into 3 areas: header, central value and footer.

Header

Footer
6.2. HEADER
The header shows the time, day and date. In addition, an information symbol is available on request or for
certain states/modes. The positions are predefi ned and cannot be changed.
Information icon
ECO mode

6.3. CENTRAL VALUE

By default, the central value indicates the room temperature value measured by the thermostat's internal
sensor.
If an external sensor is connected and the corresponding input is confi gured accordingly, this value will be
shown on the screen (Refer to the § MODBUS TABLES, page 22 - address 18).
Depending on the confi guration (Refer to the § MODBUS TABLES, page 22 - address 10), the screen may
display:
ambient temperature
²
setpoint ( )
²
setpoint offset ( )
²
Once the arrow is pressed, the values screen changes to show the setpoint adjustment submenu. The
screen then returns to the main screen after 3 seconds without action.

6.3.1. SETPOINT ADJUSTMENT

After pressing the arrows to adjust the setpoint, the main screen becomes the setpoint
adjustment screen. Pressing one of the 2 arrows again changes the value.
To adjust this setpoint, 2 options are available (Refer to the § MODBUS TABLES, page 22
- address 114):
adjust the value as an offset (not address 22)
²
adjust the desired temperature directly (basic value)
²
+ 0.5 °C
Offset adjustment
00:20 Th 07.01.16
22.3°C
1
AUTO
21.5 °C
Setpoint adjustment
Central value
Alarm