Dimensions - SystemAir TControl POD glass EC Manuel D'installation Et De Maintenance

4 TControl POD glass EC
For electric heating (up to 2,500 W), use the table below for the connection. If the unit does not come with
a built-in heating relay, the relay must be connected to the terminal according to the connections shown
below.
TControl POD glass EC terminal block-heating relay connection
Unit type
TControl POD glass EC
- output 8
TControl POD glass EC
- output 5
Caution
You must respect the minimum and maximum speed values (Refer to the § FAN MENU, page 13).

4. DIMENSIONS

Surface-mounted installation (TControl POD glass EC surface-mounted unit to be ordered as separate KIT)
The surface-mounted unit is slightly smaller than the TControl POD glass EC.
1. For ease of installation, separate the housing into two parts. Simply pull slightly on the unit in one
corner (Figure 1).
2. Then, depending on the cable entry, the push button is removed (ø20 mm backwards or ø12 mm up/
down) and deburred.
3. Attach the back of the unit to the wall. Use the attachments provided for this purpose (Figure 2).
4. The POD connection box is screwed into the upper part of the box with the 4 screws provided
(M3x8) (Figure 3).
5. Wire in accordance with the wiring diagram.
6. Place the TControl POD glass EC on the top of the unit and attach it to the rear of the unit (by clipping
it on).
Figure 1
DUCTYS SYSCOIL COMFORT VH
6 1/N
8 8
Figure 2
SYSQUARE
7 N
8 Y4
Dimensions (mm)
Figure 3