Parkside PPKS 50 B1 Traduction Du Mode D'emploi D'origine page 7

with plasma cutters with contact ignition from
Parkside� You can use the circle cutter to make
circular cuts, the diameter of these cuts can be
continuously adjusted over a range of approx� 16
cm to 100 cm� Centring can be carried out either
using a magnet or metal pin (during preparation
for each centre punch)� Please refer to the operat-
ing instructions of the plasma cutter you are using
for information about material thicknesses which
can be cut� By fixing using two magnets, you can
also perform straight cuts up to 38 cm� Use the
product only as described and only for the specific
applications as stated� Please retain the operating
instructions properly and ensure that you hand
over all documentation when passing the product
onto someone else� This product must be set up
or used only by people who have been trained
to do so� Any use that differs from the intended
use as stated above is prohibited and potentially
dangerous� Damage or injury caused by misuse
or disregarding the above warning is beyond
the liability of the manufacturer� This circle cutter
is not suitable for commercial use� Commercial
use will void the warranty� The product has been
developed for consumer use and is not suitable for
use in a commercial or industrial environment� The
product must only be started up initially by people
who have been trained to do so�
GB/IE/NI/CY/MT 7