Parkside PPKS 50 B1 Traduction Du Mode D'emploi D'origine page 9

Cut diameter:
Cutting length:
z Safety instructions
Never attach the magnets to the
plasma cutter itself or its housing�
Before use, read the full instruction
manual for the PPKS 50 B1 circle
cutter and the plasma cutter you are
using� Do not put body parts
(e�g� fingers) between the magnets
and the magnetic surfaces�
Risk of crushing!
It is essential that you observe the
safety instructions of your plasma
cutter!
Check the circle cutter before fitting
it to the plasma cutter� Damaged
components must not be used�
z Fitting circle cutter for circular cuts
Screw the rod of the circle cutter
to the torch holder with Bakelite inner ring
(Fig� D)� Screw the extension
the rod of the circle cutter
larger cutting radii (Fig� F)� Now fit the magnetic
approx� 16–100 cm
max� 38 cm
(shorter rod) to
6
1 , in order to allow
GB/IE/NI/CY/MT
(longer rod)
1
5
9