Télécharger Imprimer la page

Zanussi ZDPB274B Notice D'utilisation page 15

Publicité

Les langues disponibles

Les langues disponibles

7.
2
1
1
CLEANING THE HUMIDITY SENSOR
CAUTION! Risk of humidity sensor
damage. Do not use abrasive materials
or steel wool to clean the sensor.
To assure best drying results the appliance is
equipped with metal humidity sensor. It is placed
on the inner side of the door area.
Over usage time the surface of the sensor may get
dirty which deteriorates the drying performance.
We recommend to clean the sensor at least 3 or 4
times or if you observe the drop of drying
performance.
To clean you can use harder side of dish-washing
sponge and bit of vinegar or dish soap.
To clean the sensor:
1. Open the loading door.
2. Clean the surfaces of the humidity sensor
wiping off the metal surface several times.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
ERROR CODES
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised
Service Centre.
1
2
3
CLEANING THE DRUM
WARNING! Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent to clean the
inner surface of the drum and drum lifters. Dry the
cleaned surfaces with a soft cloth.
CAUTION! Do not use abrasive
materials or steel wool to clean the
drum.
CLEANING THE CONTROL PANEL AND
HOUSING
Use a standard neutral soap detergent to clean the
control panel and housing.
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
CAUTION! Do not use furniture
cleaning agents or cleaning agents
which can cause corrosion.
CLEANING THE AIRFLOW SLOTS
Use a vacuum cleaner to remove fluff from the
airflow slots.
15

Publicité

loading