Metabo BS 14.4 LT Impuls Notice Originale page 12

ENGLISH
ENG
Switch off the machine at the trigger (13). Then
continue working as normal. Try to prevent the
machine from seizing.
8.2 Battery pack
Charge the battery pack before use (10).
If performance diminishes, recharge the
battery pack.
"Li-Power" li-ion battery packs have a
capacity and signal indicator: (9)
- Press the (8) button, the LEDs indicate the
charge level.
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
8.3 Removing and inserting the battery
pack
Removal:
Press the battery pack release (7) button and pull
the battery pack (10) forwards.
Inserting:
Slide in the battery pack (10) until it engages.
8.4 Setting the direction of rotation, engag-
ing the transporting safety device
(switch-on lock)
Set the rotation selector switch (6).
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Central position: transport lock setting
(switch-on lock)
8.5 Selecting gear stage
Do not actuate the switch (5) unless the
motor has stopped completely!
If the switch (5) cannot be turned up to the stop,
however, press the trigger (13) slightly so that the
motor rotates slowly. It will then be possible to turn
the switch (5) all the way up to the stop.
Press the switch (5) (left or right of the machine).
1st gear setting (low speed), very high torque
2nd gear setting (high speed)
12
8.6 Setting the torque limit
Press the slide switch (4).
1... = Torque setting (for working with torque
control)
Note: the torque can be adjusted to different
settings depending on the gear
selected! In 2nd gear from 1.5 to
3.5 Nm and in 1st gear from 3.5 to
12.5 Nm.
= Drill setting - no torque control (for
max. torque)
8.7 Drilling and impact drilling (depending
on the model)
Press the slide switch (3).
= Impact drilling
Note: Always work at high speeds
when impact drilling.
= Normal drilling without impact
8.8 Activating the pulse function (depend-
ing on the model)
Do not work for long periods with pulse func-
tion switched on! (The motor can overheat.)
Press the button (11)
the pulse function.
The button (11) flashes when the pulse function is
active.
Note: If the machine is not used for approx. 5
minutes, the pulse function switches off automati-
cally and the flashing button (11) goes out.
8.9 On/Off switch, setting the speed
Switching on, speed: press the trigger (13). The
rotational speed can be changed at the
trigger switch by pressing.
Switching off: Release the trigger (13). Note: The
noise that the machine makes when it
switches off is due to the design (quick stop)
and has no influence on the function or the
service life of the machine.
8.10 LED lights
For working on dimly lit areas. The LED lights (12)
light up when the machine is switched on.
to activate or deactivate