Publicité
Les langues disponibles
Les langues disponibles
6.0 Getting Ready To Drive
6.1 Getting Ready to Drive
• Operate the On/Off switch. The screen will go through an
initializing process then show the base screen, (Fig 6.0).
• In the case of the JSM-LED the battery gauge will blink and
then remain on after a few seconds.
• Check that the Speed Setting is at a level that suits you.
• Push the joystick to control the speed and direction of the
wheelchair.
WARNING:
• If you push the joystick before or just after you switch the
control system on, the screen will flash the joystick displaced
screen (Fig 6.1).
• You must release and centre the joystick to resume normal
operation. If you do not release the joystick within five
seconds the wheelchair will not be able to move, even if you
release the joystick and push it again.
• The screen will display the diagnostic screen at this time.
You can reset this condition by switching the control system
off and on again.
Fig.6.0
Focus Indicator
Maximum Speed
Indicator
Current Profile
Profile Name
22
Indoor-Drive
MODE
PROFILE
2F01
JSM
Centre Joystick
Fig.6.1
Battery Indicator
Clock
Odometer
Speed Arc
Speed Display
R-Net Control System | Rev. H | English
Publicité
