Télécharger Imprimer la page

HIKOKI WH 18DC Mode D'emploi page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
PRECAUTIONS REGARDING THE DUST-RESISTANCE AND WATER-
PROOFING FUNCTIONS
This product conforms to IP56 protection class ratings (dust-resistance and water-proofi ng) for electrical equipment as
stipulated by the international IEC regulations. (Only the main unit conforms to the IP56 protection class ratings when
equipped with a battery.)
[Descriptions of IP Codes]
IP56
Protection rating for water penetration
Must be no adverse eff ects on the equipment when sprayed with powerful jets of water from all directions (water-
proofed).
(100 L of water per minute sprayed for approximately three minutes from a distance of approximately three meters
with the use of a spray nozzle with a diameter of 12.5 mm.)
Protection rating for external assault by solid objects
Dust that may cause adverse eff ects on the equipment must not be able to enter (dust-resistance).
(The equipment to be left non-operable in a test chamber in which particles of talcum powder with a diameter of less
than 75 μm are fl oating in the air with the use of an agitation pump at a rate of 2 kg per cubic meter for eight hours.)
The equipment has been designed to withstand the eff ects of dust and water, but there is no guarantee that it will not
malfunction. Do not use or leave the equipment in locations where it is subject to excessive amounts of dust, or in locations
where it is submerged in water or subject to rainwater.
NAMES OF PARTS (Fig. 1–Fig. 14)
Protector
Hammer case
Guide sleeve
LED Light
Trigger switch
Switch panel
Battery
Hook
Handle
Push button
Housing
Color plate
(sold separately)
Latch
Pilot lamp
Charge indicator lamp
Driver bit
(sold separately)
Groove
Screw
Remaining battery
indicator switch
Remaining battery
indicator lamp
Display panel
Light section switch
Tightening mode
selector switch
Tightening mode
indicator lamp
Rubber cover
USB port
USB cable
9
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WH18DC: Cordless Impact Driver
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
Direct current
V
Rated voltage
English

Publicité

loading